Alfa Romeo Veloce Engine 1290cc 750 Series
- 5500.00 £
- Published date: March 14, 2024
-
- Dartmoor National Park, Devon, United Kingdom
Alfa Romeo Veloce Engine 1290cc 750 Series
⭕ Completely rebuilt:
Alfa Romeo Engine Specifications:
1954-1958 750 Series Veloce Un-Numbered Block
1290CC (1300cc Nominal) Engine
Engine Block
-Align Honed - not bored and Align Polished
-Oil Passages drilled and tapped for full oiling of cylinders #2 and #4
-Oil passages scrupulously deburred and cleaned multiple times
-Block pressure washed and then steam cleaned 3 times in succession, high pressure solvent and steam injection in all oil passageways.
-Oil passages sealed with Allen set screws and Green Loctite
Crankshaft
-Crankshaft polished and cut undersize - 0.0010 (ten thousandths) under rod & main bearings installed (OEM NOS Federal Mogul bearings)
-All crankshaft oil passages drilled, cleaned and tapped and threaded, Allen plugs installed with Green Locktite, crank rebalanced
-Rod Journals #2 and #3 drilled and tapped from both sides for full oiling of #2 and #3 rods
-Crankshaft, slinger, spacer, timing gear, front pulley, flywheel and pressure plate static and harmoniously balanced
-NOS OEM main bearing cap washers, nuts and locknuts installed
Rods
-New upper rod bushings installed & reamed to proper wrist pin
tolerances
-Rods shot peened
-Rods balanced
-Rods sized big and little ends
-New OEM Veloce high strength rod bolts installed
Pistons & Liners
-NOS pistons balanced and installed with wrist pins and rings,nominal displacement 1290 ccs.
-NOS OEM piston liners honed for pistons
-Total Seal NOS piston rings installed
-Final Sun Honing Stone cross-cut on piston liner bores
Flywheel
-Flywheel pressure washed and cleaned, shot peened and re-surfaced with Sun Honing Stone
-NOS OEM Sachs pressure plate and clutch driven disc
-Flywheel, pressure plate and clutch driven disc static balanced
-NOS OEM 17mm flywheel retaining bolts and half moon flywheel
lock plates installed with Red Locktite and NOS locking plates
-NOS OEM 750 Veloce Ring Gear installed and balanced
Oil Pump
-Full rebuild with NOS OEM oil pump relief piston, spring and end cap installed
-oil pump pressure relief valve plunger bore cleaned and chamfered
-high capacity oil pressure plunger relief spring installed
-oil pump housing milled to correct tolerance
-high capacity gears installed, shimmed
-gear play checked and set
Water Pump
-Full rebuild with NOS OEM impellor, shaft, bearings and installed
-Upgraded stainless steel impellor seal installed
Cylinder Head
-stock head height head surfaced minimum 10 thousandths material removed
-first stage intake and exhaust ports ported, polished and matched
-head surface polished after re-surfacing & porting operations
-cylinder head pressure washed and steam cleaned three time in succession after surfacing, porting and polishing operations
-NOS valves, guides, springs, seats and seals installed
-Isky racing valve springs installed, heights set
-Camshaft clearances set at 0.0018 (18 thousandths intake) 0.0020 (20 thousandths) exhaust
-Stock intake manifold ported, polished and enlarged, then matched to cylinder head intake ports
-Special high strength German made Reinz reinforced head gasket installed
Misc. Engine Equipment
-NOS OEM Timing Chains - upper and lower
-NOS OEM Timing Sprocket spring, set plate and bolt
-Original timing sprocket assembly dis-assembled and properly rebuilt for low running stress relief of reciprocating gear
-NOS OEM complete gasket set
-Rebuilt Bosch JF-4 ignition distributor
Alfa Romeo Engine Specifications:
1954-1958 750 Series Veloce Un-Numbered Block
1290CC (1300cc Nominal) Engine
Engine Block
-Align Honed - not bored and Align Polished
-Oil Passages drilled and tapped for full oiling of cylinders #2 and #4
-Oil passages scrupulously deburred and cleaned multiple times
-Block pressure washed and then steam cleaned 3 times in succession, high pressure solvent and steam injection in all oil passageways.
-Oil passages sealed with Allen set screws and Green Loctite
Crankshaft
-Crankshaft polished and cut undersize - 0.0010 (ten thousandths) under rod & main bearings installed (OEM NOS Federal Mogul bearings)
-All crankshaft oil passages drilled, cleaned and tapped and threaded, Allen plugs installed with Green Locktite, crank rebalanced
-Rod Journals #2 and #3 drilled and tapped from both sides for full oiling of #2 and #3 rods
-Crankshaft, slinger, spacer, timing gear, front pulley, flywheel and pressure plate static and harmoniously balanced
-NOS OEM main bearing cap washers, nuts and locknuts installed
Rods
-New upper rod bushings installed & reamed to proper wrist pin
tolerances
-Rods shot peened
-Rods balanced
-Rods sized big and little ends
-New OEM Veloce high strength rod bolts installed
Pistons & Liners
-NOS pistons balanced and installed with wrist pins and rings,nominal displacement 1290 ccs.
-NOS OEM piston liners honed for pistons
-Total Seal NOS piston rings installed
-Final Sun Honing Stone cross-cut on piston liner bores
Flywheel
-Flywheel pressure washed and cleaned, shot peened and re-surfaced with Sun Honing Stone
-NOS OEM Sachs pressure plate and clutch driven disc
-Flywheel, pressure plate and clutch driven disc static balanced
-NOS OEM 17mm flywheel retaining bolts and half moon flywheel
lock plates installed with Red Locktite and NOS locking plates
-NOS OEM 750 Veloce Ring Gear installed and balanced
Oil Pump
-Full rebuild with NOS OEM oil pump relief piston, spring and end cap installed
-oil pump pressure relief valve plunger bore cleaned and chamfered
-high capacity oil pressure plunger relief spring installed
-oil pump housing milled to correct tolerance
-high capacity gears installed, shimmed
-gear play checked and set
Water Pump
-Full rebuild with NOS OEM impellor, shaft, bearings and installed
-Upgraded stainless steel impellor seal installed
Cylinder Head
-stock head height head surfaced minimum 10 thousandths material removed
-first stage intake and exhaust ports ported, polished and matched
-head surface polished after re-surfacing & porting operations
-cylinder head pressure washed and steam cleaned three time in succession after surfacing, porting and polishing operations
-NOS valves, guides, springs, seats and seals installed
-Isky racing valve springs installed, heights set
-Camshaft clearances set at 0.0018 (18 thousandths intake) 0.0020 (20 thousandths) exhaust
-Stock intake manifold ported, polished and enlarged, then matched to cylinder head intake ports
-Special high strength German made Reinz reinforced head gasket installed
Misc. Engine Equipment
-NOS OEM Timing Chains - upper and lower
-NOS OEM Timing Sprocket spring, set plate and bolt
-Original timing sprocket assembly dis-assembled and properly rebuilt for low running stress relief of reciprocating gear
-NOS OEM complete gasket set
-Rebuilt Bosch JF-4 ignition distributor
Phone number ✆ 01752 658942
Dartmoor National Park, Devon
Related listings
-
-
MERCEDES CLC200 GREAT CONDITION LOW MILE...
AUTO PARTS Brackley (Northamptonshire) April 23, 2024 5650.00 £ -
BMW Genuine E90 E91 E92 E82 Performance ...
AUTO PARTS Ullesthorpe (Leicestershire) April 23, 2024 1700.00 £
-
Mitsubishi Evolution EVO 4 / 5 Speed H P...
AUTO PARTS Quorn (Leicestershire) April 22, 2024 2700.00 £ -
-
-
BMW DINAN E36 SUPERCHARGER M50 S50 325I ...
AUTO PARTS Wigston (Leicestershire) April 21, 2024 1200.00 £ -
-
-
-
BMW 235 Getrag Close Ratio 5 Speed Trans...
AUTO PARTS Glenrothes (Scotland) April 20, 2024 1450.00 £ -
Dodge Ram HEMI Truck 5.7L Procharger D-1...
AUTO PARTS Brighton (East Sussex) April 20, 2024 1600.00 £
-
-
-
Used Evinrude 250 High Output Direct Inj...
AUTO PARTS Charlecote (Warwickshire) April 19, 2024 2000.00 £
-
-
JDM 97 ACURA INTEGRA B18C GSR MOTOR 1.8L...
AUTO PARTS Sutton On Sea (Lincolnshire) April 19, 2024 1700.00 £ -
-
-
1963-1964 Corvette Rochester Fuel Inject...
AUTO PARTS Great Saling (Essex) April 18, 2024 1900.00 £ -
-
Corvette 427 Tripower 1967 390 And 400 H...
AUTO PARTS Rotherwick (Hampshire) April 18, 2024 1800.00 £ -
-
98 01-04 LS1 LS6 Engine T-56 Transmissio...
AUTO PARTS Chesham (Buckinghamshire) April 18, 2024 1000.00 £
-
Nissan Leaf Electric Vehicle Charging Ca...
AUTO PARTS Stoke On Trent (Staffordshire) April 18, 2024 150.00 £ -
-
ENGINE BMW M3 2008/E90 E92 BMW/BMW M3 EN...
AUTO PARTS Pudsey (West Yorkshire) April 18, 2024 1500.00 £
-
-
-
COSWORTH 4X4 BIG TOOTH GEARBOX GEAR KIT ...
AUTO PARTS Westcliff on Sea (Essex) April 17, 2024 1600.00 £
-
-
BBS E50 CENTERLOCK MAGNESIUM MOTORSPORT ...
AUTO PARTS Near Sawrey (Cumbria) April 17, 2024 1400.00 £ -
FUll Vortech Supercharger Kit V3 03-04 S...
AUTO PARTS Stone (Staffordshire) April 17, 2024 1300.00 £
-
-
-
2010 Lamborghini Murcielago 6.5 LP640-Di...
AUTO PARTS Tunbridge Wells (Kent) April 17, 2024 1800.00 £
-
-
Flir M324XP Thermal Night Vision Camera
AUTO PARTS Knaresborough (North Yorkshire) April 17, 2024 1500.00 £ -
-
-
-
Lotus Twin Cam Race Engine.Race Car,Lotu...
AUTO PARTS Basingstoke (Hampshire) April 16, 2024 2200.00 £
-
Cessna R182 Main Landing Gear Pivot P/N ...
AUTO PARTS Towcester Silverstone (Northamptonshire) April 16, 2024 5600.00 £ -
-
2008 EVINRUDE E-TEC 300 HP 30 DI OUTBOAR...
AUTO PARTS Hickstead (West Sussex) April 16, 2024 2700.00 £
-
WWII JAPANESE NAVY TYPE 96-1 TRANSMITTER...
AUTO PARTS Gatwick (West Sussex) April 16, 2024 2200.00 £ -
-
YAMAHA 200hp 200 HP VF200LA Outboard Mot...
AUTO PARTS Markyate (Hertfordshire) April 16, 2024 2800.00 £